Factors affecting the service life of straw pellet machine

Xinchao Machinery specializes in the development of energy equipment for 16 years. It mainly produces high-quality straw pellet machines and other equipment. Straw pellet machines use crop straw or sawdust as raw materials, and are compressed into cylindrical pellets by straw pellet mills.
Here I introduce to you the factors that affect the life of the straw pellet machine.
1. The moisture of the material is too low, the hardness of the processing object is high, the power consumption during processing increases, the production cost of the enterprise is increased, and the service life of the straw pellet machine is reduced. If the moisture is too large, it is not easy to crush and the impact of the hammer is increased. The number of times, at the same time, due to the friction of the material and the impact of the hammer, the heat is generated, so that the moisture inside the processing object evaporates, and the evaporated water and the crushed fine powder form a paste and block the sieve hole, thereby reducing the discharge of the crusher. Such as cereals, corn and other moisture are controlled below 14%
2. When the material pressing is about to end, mix a little wheatmeal cooking oil and put it into the machine, stop it after pressing for 1-2 minutes, so that the mold hole is filled with oil, so that the next boot will be able to feed production, maintenance of the mold, It also saves man-hours. After the straw pellet machine shuts down, it loosens the pressure roller adjustment screw and removes the residual material.
3, can be installed in the machine feed port permanent magnet, or iron remover, so as not to affect the life of the roller, mold and center shaft. By the straw particles in the extrusion process temperature up to 50-85 °C, and the pressure roller in operation When working under strong power, but lacking the necessary and effective dust protection device, every 2-5 working days, the bearings must be cleaned and high-temperature grease must be added. The main spindle of straw pellet machine every other month Cleaning and refueling once, the gear box should be cleaned and maintained at intervals of six months. The screw fastening of the transmission part should be replaced at any time.
After a while, it is the season of harvesting straw and wheat husk. Now the country has vigorously advocated environmental protection and energy. If you have the intention to visit the factory, you can also call the hotline to obtain first-hand information.