Feed pellet machine common faults and troubleshooting

1. The output is too low (even if no pellets are produced) Cause of failure 1. The first time the die is used, the smoothness of the die hole is poor; 2. The moisture content of the material is too high or too low; 3. The gap between the pressure roller and the flat die is too large; 4. The pressure roller Or flat die grinding buckle serious; 5. V-belt skid or aging. Remedy 1. Lubricate and lubricate with oil, increase the output for a period of time; 2. Adjust the moisture content of the material; 3. Adjust the compression bolts; 4. Tighten or replace the V-belt; 2. Excessive powder in the particles Low water content; 2. Excessive wear on the flat die, too small thickness. Remedy 1. Increase the moisture content; 2. Replace the new flat mold. Third, the rough performance of particles Causes of failure 1. High moisture content; 2. First use of flat die. Remedy 1. Reduce the moisture content; 2. Repeat grinding with oil. 4. Abnormal noise causes 1. Fall into hard debris 2. Bearing damage 3. Loose parts. Remedy 1. Stop and remove foreign objects; 2. Replace bearings; 3. Fasten parts. V. Causes of Sudden Stopping Failure 1. The load is too large (even the fuse is blown); 2. Foreign matter enters the cavity. Remedy 1. Increase the clearance between the pressure roller and the flat die to replace the fuse. 2. Stop and remove the foreign object.