Feed pellet machine common faults and troubleshooting

I. Production is too low (even without pellets)
cause of issue
1. The difference in the smoothness of the first-use die hole in the flat die;
2. The material moisture content is too high or too low;
3. The gap between the pressure roller and the flat die is too large;
4. The pressure roller or flat die grinding buckle serious;
5. V-belt skid or aging.
Method of exclusion
1. Grinding and lubricated with oil, the output is increased for a period of time;
2. Adjust the moisture content of the material;
3 . Adjust the compression bolts;
4 . Tighten or replace the V-belt 2. The reason for excessive powder in the particles
1. Low moisture content;
2. The flat die is excessively worn and the thickness is too small.
Method of exclusion
1. Increase the moisture content;
2. Replace the new flat die.
Third, the rough performance of the particles causes
1. High moisture content;
2 first use of flat die.
Method of exclusion
1. Reduce the moisture content;
2. Repeat grinding with oil.
Fourth, abnormal sound failure
1. Fall into hard debris;
2 bearing damage;
3 . Loose parts.
Method of exclusion
1. Stop the removal of foreign objects;
2. Replace the bearing;
3. Fasten the parts.
V. Sudden Parking Failure Cause
1. The load is too large (even the fuse blows);
2. Foreign matter enters the cavity.
Method of exclusion
1. Properly increase the gap between the pressure roller and the flat die to replace the fuse;
2. Stop the removal of foreign objects.