Precautions for starting and stopping the sawdust pellet machine

Nowadays, many sawdust pellet machines have made certain progress in the technology of starting and stopping, and it has become more and more simple, but it still needs to be controlled manually.

Therefore, there may still be misunderstandings in the process of starting and stopping, which means that there are still many things that need to be paid attention to.

Let's follow our granulator manufacturers to see the precautions for starting and stopping the sawdust granulator.

When the sawdust granulator is turned on, when the host button on the electric control cabinet is pressed, it will run idly, but it has not really started at this time, and it cannot be granulated or added to the oil to wash the mold. Adjust the current and wait for the ammeter. After it shows that the current is normal, put some greasy material first, rinse the ring die for about a minute, it is very necessary to heat up the ring die, and then when the material slowly squeezes out the oil from the last shutdown, there will be no forming. Or semi-formed material particles, therefore, it is necessary to wait for the forming rate to increase before feeding normally.

At the beginning of feeding, the feeding amount should not exceed 20% of the production capacity of the equipment. It is necessary to prevent the phenomenon of machine blockage or mechanical damage caused by sudden increase of load due to too much material fed in an instant.

When the material is quenched and tempered, it can be formed into a ball when you grasp it tightly, and it can be spread out after you let go. At this time, close the feeding door cover and press it.

When the sawdust pellet machine is ready to stop, firstly increase the raw material of oil-containing material to clean the molding material in the mold, check the oil material from the observation room and replace the sawdust pellets, close the feeder first, and wait for the equipment to stop discharging. Shut down the host again.

When adding oil material, it should be added slowly, too fast will lead to abnormal discharge or no material immediately. As a result, it is necessary to check whether there is accumulated material in each part, turn off the main power supply of the equipment system, and do a good job of follow-up cleaning.

The above are the precautions for starting and stopping the sawdust granulator. In this process, there are actually many details that we need to pay attention to. For example, the feeding sequence and feeding amount of materials and oil will affect the smoothness of the equipment startup and shutdown, and then affect the pellets. The performance of the machine equipment and the quality of material granulation.