【Truth】The correct operation process of wood pellet mill

Proper start-up procedures are critical for wood pellet mills. Many users think that they have mastered the startup process of the device and do not need to pay attention during use. In fact, this often poses a security risk. Because in the process of using the device, any detail can affect the result. It is important to operate the Wood Pellet Mill in accordance with the correct operating procedures.

1. When pressing the main engine button on the electric control cabinet, the sawdust pelletizing machine starts to run, but at this time, the sawdust pelletizing machine has not really started well, and neither pelletizing nor oil can be added to wash the mold.

2. After the delay start of the equipment, after the ammeter shows that the current is normal, it is necessary to put in some greasy materials and rinse the ring die for about one minute, so that it is very necessary to heat the ring die.

3. At the beginning of feeding, the feeding amount should not exceed 20% of the production capacity of the pellet machine, to prevent the sawdust pellet machine from feeding too much material in an instant, and the load suddenly increases, resulting in blockage or mechanical damage.

4. When the material is quenched and tempered, it can be formed into a ball when it is grasped tightly, and it can be scattered after letting go. At this time, close the feeding door cover and press it.

In the processing of the sawdust pellet machine, it is necessary to observe whether the current of the main machine is stable, and adjust the feeding amount and the amount of steam added according to the production performance and current load of the sawdust pellet machine. The feeding amount must be gradually adjusted from low speed to high speed, and the amount of steam added should be adjusted according to the dry humidity of the material. The pellet machine should avoid overloading, which may easily lead to ring die rupture and damage to the pellet machine. Users should not be careless and impatient when using the new mold. Before the new mold reaches a good production capacity, it is necessary to run in moderately.