5 major factors that affect the poor performance of wood pellet mills, have you encountered them?

With the continuous development of economy and society, greening, gardens, orchards, furniture factories and construction sites will produce countless sawdust wastes every day. The renewable utilization of resources and the environmental protection machinery market are also developing continuously. Renewable utilization makes this sawdust pellet machine form a new generation, environmentally friendly, energy-saving and intelligent sawdust resource renewable utilization industry. This pellet machine has uniform discharge particle size, strong material adaptability, low energy consumption, and uses Wide and other advantages.

The sawdust granulator will produce a lot of granular powder during production. The sawdust sticks to the particles, which affects the shape of the particles and leaves the customer with the impression of poor quality of the particles. It is more difficult to remove the powder with viscous particles. Today Kingoro engineers will help you analyze the reasons.

1. If the Wood Pellet Machine is a new machine purchased, if it has not been ground with wet or oil, this is a problem that many people tend to ignore.

If you ignore this link, it is likely to cause the machine to be blocked as soon as the machine is turned on. Of course, powder will appear. Therefore, for the purchased pellet machine, you must take some wood chips that will be pressed pellets, and mix them into about 10% industrial Use oil, such as normal motor oil.

2. The sawdust particles may also be that the moisture content of the sawdust is too low. The moisture content of sawdust is too low, making it difficult to extrude. Generally speaking, the ideal humidity for granulation is 15 to 20 percent. The granulation effect is good between this humidity. If the humidity of the raw material is too low, the solution is very simple. Simple, just spray some water.

3. The operation is unreasonable, there are too many materials, and the machine cannot work normally. Another is that the design of the machine itself is defective, which leads to the occurrence of gaps. If there is powder due to these two reasons, the solution is to stop first. Feed the material, then turn on the machine to clean up the material.

4. The machine is aging, the speed of the main engine is slowed down, the frequency is different, and some raw materials cannot be processed, which generally appear in some old-fashioned machines.

5. The granulation system fails, which is not what we want, but it is also a frequent mechanical failure.

The failure is mostly due to the damage of the granulator caused by the unclean material and the hard objects, and the problem of the bearing may also cause this problem.

It is also possible that the mold in the machine is damaged. If the pressure roller skin is seriously worn, the granulation effect will definitely be greatly reduced. There is no good solution to this problem, and you can only buy a new pressure roller skin. In fact, the machine also needs to rest, if you use it all the time, it can not guarantee the quality, so also pay attention not to use it for too long.

The Wood Pellet Mill can promote the recycling efficiency of wood chips resources.