How to deal with the phenomenon of sawdust pellet machine shaft slipping

When using the sawdust pellet machine, if the axial pressure slips, it will affect the production of pellets, so be sure to pay attention to this situation in time.

To ensure the working efficiency and production quality of the machine, what is the reason for the slippage of the sawdust pellet machine axis? Now I will tell you in detail the factors and treatment methods of the shaft pressure slip of the sawdust pellet machine.

1. The bearing installation of the sawdust pellet machine is not very flexible, which will cause the shaft to slip.

When installing the bearing of the sawdust pellet machine drum, please do not install it too hard, otherwise it will cause the sawdust pellet machine to slip during the pelletizing process. A good way to deal with this situation is to keep an eye on the axial pressure of the roller and replace it with a new roller immediately.

2. Too much water content in the pellets will affect the phenomenon of axial pressure and slippage

When the sawdust pellet machine squeezes the raw material, the moisture content in the raw material is too much, or the steam caused by the sawdust pellet machine is too large, and the axial pressure of the sawdust pellet machine is caused by the lubrication of the moisture content during the production process. A good way to deal with this is to reduce the amount of steam in the raw material and keep the water content in the raw material within a reasonable range.

3. The axial pressure gap of the sawdust granulator is too large, which will affect the phenomenon of axial pressure slippage

When the granulator is used, if the gap between the axial pressure of the sawdust granulator is not effectively adjusted, the pellets caused by the granulation process are not very uniform, the production volume is small, and the sawdust granulator cannot be compressed. The phenomenon that the pressed material is easily slipped by the shaft. A good solution can reduce the distance between the two spindles of the sawdust pellet machine.

4. Excessive application of the axial pressure of the Sawdust Pellet Mill will affect the slippage of the axial pressure

Prolonged use of pellets can cause axial pressure wear (a fundamental component failure), which in turn can cause axial pressure slippage conditions and will not function properly. A good way to deal with the phenomenon of pellet mill shaft pressure slippage is not only to keep the pellet machine clean from time to time, but also to replace the new shaft pressure at any time.

The above are the phenomenon factors and treatment methods about the shaft pressure slippage of the sawdust pellet machine, and I look forward to helping you.