The problem and treatment of the slippage of the final shaft of the sawdust granulator

Under what circumstances does the Sawdust Pellet Mill generally experience the slippage of the finale? How to deal with it?

The problem of slippage of the finale of the sawdust granulator and its solution:

1. Too much clearance between the press shaft of the granulator will affect the sliding of the final shaft

When we use the pellet machine for operation, if we do not control the gap between the press shafts of the pellet machine, it is easy for the pellets produced during the pelletizing process to be not uniform enough, the output is too small, and the press of the pellet machine cannot be tightened tightly. Press the material tightly, so that the finale will easily slip.

A good solution to this problem is to reduce the distance between the two main shafts of the pellet mill.

2. Excessive water content of granular raw materials will affect the slippage of the finale

When the raw material is pressed by the sawdust granulator, the moisture content of the raw material is too large or the steam generated when passing through the equipment is large, which will cause the pellet machine to be pressed due to the lubrication effect of moisture during the material operation of the pellet machine. Slippage occurs.

The best way to solve this problem is to reduce the amount of steam introduced into the raw material and keep the water content of the material within a reasonable range.

3. The bearing installation of the granulator is not flexible enough to cause the sliding shaft to slip

When installing the bearing of the pellet machine, do not install it too dead, otherwise it will cause the Biomass Pellet Machine to slip during the pelletizing operation.

The best way to solve this problem is to always pay attention to the final shaft of the press, even if it is replaced with a new one.

4. Excessive use of the finalizer of the granulator will affect the sliding of the finalizer

If the Wood Pellet Mill is used for a long time, it will lead to the wear of the finale and the phenomenon of slippage of the finale, and it cannot work normally.

The best way to solve this problem is not only to keep cleaning the equipment, but also to replace the new pressure roller at any time.

Do you understand the problem of slippage of the finale of the wood pellet mill? Will it be dealt with?