Teach you how to check the low output of sawdust pelletizer

Because different pellet mill manufacturers have developed different pellet machines with different technologies, different structures and different specifications, and different types and models, the output produced is also different.

Everyone is not too unfamiliar with these. To be honest, there are actually many reasons that affect the output of the sawdust pelletizer. In order to improve the production efficiency of the sawdust pelletizer, it is necessary to summarize experience from practice and check the sawdust one by one during the production process. Granulator and solve the problem. Among them, the following factors are the conclusions drawn by the technicians of the pellet machine manufacturer in practice for your reference:

1. If the sawdust pelletizer uses a new ring die in the production process, first check whether the compression ratio of the ring die matches the raw material produced. The ring die compression ratio of the sawdust pelletizer is too large, and the pellets are pressed out. If it is too hard and the output value is low, it is necessary to adjust the compression ratio of the ring die of the sawdust pelletizer.

If the ring die of the sawdust granulator has been used for a period of time, it is necessary to check whether the inner wall cone hole of the sawdust granulator ring die is worn, and whether the pressure roller is worn. If the pressure roller of the sawdust granulator is seriously damaged, it is necessary to replace the pressure roller.

2. Check the lubricating degree of the inner hole of the ring die of the sawdust granulator and whether the ring die is out of round. Some defective ring dies will have rough inner holes, and the ring die will be out of round, resulting in unlubricated materials, uneven particles, and out-of-round. The material is relatively slow and the output value is also low, so a high-quality ring die should be selected.

The gap between the ring die and the pressing roller needs to be adjusted properly. Too small distance will increase the conflict between the pressing roller and the ring die, which will shorten the use time of the ring die. The roller gap is 0.3-0.5mm. The correct operation method is to use the label paper of the certificate, and put it between the pressing roller and the mold, which helps to adjust the distance between the mold and the pressing roller correctly.

3. Control the moisture content of the raw material of the sawdust granulator to keep about 15%. If the moisture content of the raw material is too high, the mold resistance and slippage will appear after the raw material enters the ring die, and the moisture content of the raw material should be controlled within the range of 13-20%.

Check the distribution of raw materials in the ring die, so that the raw materials are evenly distributed in the ring die, which can not only prolong the service life of the ring die, but also smoothly discharge the wood pellets.

The Wood Pellet Machine is not running smoothly, and the bearing runs outside the circle.
The technicians of the Kingoro pellet machine manufacturer will explain to you several relevant factors that affect the output of the wood pellet machine, hoping to help everyone, reduce the problems encountered by users in the production process, and effectively improve the production output of users.